The walls and attic are now air sealed. The cement slab was air sealed several months ago when I completed the framing, but several parts had deteriorated while it had been exposed to the elements so I touched up those …

Step 22b – Ceiling Drywall Read more »

With a break in bad weather, it was high time to get going on installing the siding. Tyvek water resistant barriers are designed to be protected by siding and will break down if they are left uncovered for too long. …

Step 21 – Install Exterior Siding Read more »

The last section of the house to be dried in are the gable ends.  The gable end trusses cover an area of the house that is not heated, so it doesn’t need to be insulated.  For this reason, I won’t …

Step 16c – Sheathe/WRB the Gable Ends Read more »

Windows allow heat to enter the home via radiation from the sun, and allow heat to both enter and exit the home via conduction (windows are much better conductors of heat than insulated walls).  To mitigate this issue, I paid …

Step 16b – Install the Windows Read more »

With the house completely wrapped in a cozy layer of polyiso foam, I was now prepared to add the water resistant barrier.  The Tyvek WRB comes in a 9 foot roll, and should be stretched taut across the surface of …

Step 16a – Attach the WRB Read more »

The roof has been doing a fine job protecting the house, but as there is a ton of wind in my area, the walls are just as vital to preventing water from damaging the house.  The plywood sheathing has been …

Step 16 – Complete “Dry-In” Read more »